“P” Group: Other Parameters; Option Card Error; Section 4 - Omron 3G3MX2 User Manual

"P" Group: Other Parameters
3-9 "P" Group: Other Parameters
3-9-1

Option Card Error

Func.
Code

3-9-2 Encoder (Pulse Train Input) Related Settings
Func.
Code








P group parameters are for other functionality such as option error, encoder
(pulse train input) settings, torque command, positioning command, Drive
Programming and communication (CompoNet, DeviceNet, EtherCAT, Profi-
Bus, CAN Open) related.
You can select how the inverter reacts when an error results from a built-in
option card.
"P" Function
Name
Operation selection at option 1
error
You can achieve speed control or simple positioning control by using pulse
train input. Following table shows the related parameters of those function.
Please refer to SECTION 4 Operations and Monitoring on page 191 for the
detailed description.
"P" Function
Name
EA terminal selection
Pulse train input mode for
feedback
Encoder pulses
Simple positioning selection
Creep pulse ratio
Creep speed
Overspeed error detection
level
Speed deviation error
detection level
Description
Two option codes:
... Trip
... Continues operation
Description
Three option codes:
... FQ set
... Encoder FB
... EzSQ
Four option codes:
...Single-ph.
...2-ph.1
...2-ph.2
...Single+Dir
Sets the pulse number (ppr) of the
encoder, set range is 32~1024
pulses
Two option codes:
...OFF
...ON
0.0 to 400.0
Set range is start frequency
(b082) ~10.00 Hz
Set range is 0.0~150.0%
Set range is 0.00~120.00 Hz
Section 3-9
Run Defaults
Mode
EU Units
Edit

00 –
Run Defaults
Mode
EU Units
Edit

00 –

00 –

512 –

00 –

125.0 %

5.00 Hz

115.0 %

10.00 Hz
179