Analog Output Calibration Related Functions - Omron 3G3MX2 User Manual
Mx2 series 200 v class three-phase input 0.1 to 15 kw 200 v class single-phase input 0.1 to 2.2 kw 400 v class three-phase input 0.4 to 15 kw
Hide thumbs
Also See for 3G3MX2:
- User manual (440 pages) ,
- Quick start manual (53 pages) ,
- Connection manual (34 pages)
Table of Contents
Advertisement
"C" Group: Intelligent Terminal Functions
Func.
Code
!Caution Do not change the debug mode for safety reasons. Otherwise unexpected
3-7-9
Analog Output Calibration Related Functions
Func.
Code
"C" Function
Name
Reset frequency matching
selection
UP/DWN clear mode
*1
Not only for Up/Down function, it also save the content of F001 when the reference is give by digital operator.
performances may occur.
These functions are for adjustment of analog output FM and AM. The outputs
are adjusted at factory before the shipment, and therefore basically no need
to adjust at the customer. But in case you need to change the gain depending
on your system (i.e. analog meter specification), you can use these functions
for the adjustment.
"C" Function
Name
EO gain setting
AM gain setting
AM bias setting
Description
Determines the restart mode after
reset is given, three option codes:
... 0 Hz start
... f-match (Frequency
matching start)
... Actv.f-match (Active
Frequency Matching restart)
Freq. set value when UDC signal
is given to the input terminal, two
option codes:
... 0 Hz
... Pow-ON data
Description
Set range is 50 to 200%
Set range is 50 to 200%
Set range is 0 to 100%
Section 3-7
Run
Defaults
Mode
EU
Units
Edit
00
–
00
–
Run
Defaults
Mode
EU
Units
Edit
100
%
100
%
0
%
169
- Quick Links:
- Configuring Drive Parameters
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
