Preset Position Function; Positioning With Brake Control - Omron 3G3MX2 User Manual

"P" Group: Other Parameters
ORG input
ORL input
Outut Freq.
ORG input
ORL input
Outut Freq.
3-9-9

Preset Position Function

3-9-10 Positioning with Brake Control

188
(1) Low speed homing (P068 = 00)
ON
[2]
[1]
Home position
(2) High speed homing (P068 = 01)
ON
[2]
[1]
Home position
If the P083 parameter is not 0, when Input terminal function, "PSET(91)"
which added newly as a set range of C001 to C007" is ON. the inverter set a
value of (P083x4) into a current position inside level.
Here, P083 is the value that is not 4 multiply like a position command.
This function is effective about P075 (Positioning Mode Selection) = 00, 01
both sides.
Func. Name
Code

Preset position data
In the case of brake control significance (b120=01), close brakes with the
position management end in simple position control significance (P012=02).
Ignore b127 as brakes injection frequency then and apply P015 (creep speed-
setting) automatically.
In the case of brake control function is enabled (b120=01) and simple posi-
tioning function is enabled (P012=02), the inverter turns Brake ON, when
position management was terminated. At this time, the inverter automatically
ignores (b127) and applies Creep sped setting (P015) as Brake on frequency.
ON
Low speed (P070)
[3]
Position
ON
High speed (P071)
[3]
Position
[5]
Low speed (P070)
[4]
"P" Function
Setting Range
-268435455 to 268435455
Section 3-9
[1] Acceleration up to the speed P070.
[2] Running at low speed P070
[3] DC braking when ORL signal ON
[1] Acceleration up to the speed P071.
[2] Running at high speed P071
[3] Deceleration when ORL signal ON
[4] Running at low speed P070 in
reverse direction
[5] DC braking when ORL signal OFF
Run Defaults
Mode
EU
Edit

0
Units
–