HP Integrated Lights-Out User Manual page 113

When the Terminal Services pass-through option is set to Enabled or Automatic
on the Global Settings page and the Terminal Services Client is installed on the
Windows® client (installs by default on Windows® XP), the Terminal Services
button is enabled. When the Terminal Services button is clicked, the applet tries
to launch the Terminal Services, even if the server is not running a Windows®
operating system.
You must comply with Microsoft® license requirements which are the same as
connecting through the server's NIC. For instance, when set for administrative
access, Terminal Services does not allow more than two connections, regardless
of whether the connections are through the server's NIC or iLO or both.
Terminal Services Pass-Through Status
The iLO Status page displays the status of the Terminal Services pass-through
feature, as follows:
The UID light flashes whenever a Terminal Services connection is active through
the iLO. It flashes at the same frequency and duty cycle as when the Remote
Console is active.
Terminal Services Warning Message
Terminals Services users operating on Windows® 2003 Server might notice the
following when using the Terminal Services pass-through feature of iLO. If a
Terminal Services session is established through iLO and a second Terminal
Services session is established by a Windows® administrator (Console mode),
the first Terminal Services session is disconnected. However, the first Terminal
Services session does not receive the warning message indicating the
disconnection until approximately one minute later. During this one-minute
period, the first Terminal Services session is available or active. This is normal
behavior, but it is different than the behavior observed when both Terminal
Services sessions are established by Windows® administrators. In that case, the
warning message is received by the first Terminal Services session immediately.
Server software not detected
Available for use
In use
Using iLO 113