Mod_Network_Settings Parameters - HP Integrated Lights-Out User Manual

Remote Insight Command Language 291

MOD_NETWORK_SETTINGS Parameters

If the following parameters are not specified, then the parameter value for the
specified setting is preserved. Zero values are not permitted in some fields.
Consequently, an empty string deletes the current value in some fields.
ENABLE_NIC enables the NIC to reflect the state of iLO. The values are "Yes"
or "No." It is case insensitive.
SHARED_NETWORK_PORT is used to set the iLO Shared Network Port value.
The values are "Yes" or "No." The Shared Network Port command is supported
on ProLiant 3xx G4 series servers.
SPEED_AUTOSELECT is a Boolean parameter to enable or disable the iLO
transceiver to auto-detect the speed and duplex of the network. This parameter is
optional, and the Boolean string must be set to "Yes" if this behavior is desired.
If this parameter is used, the Boolean string value must never be left blank. The
possible values are "Yes" or "No." It is case insensitive.
FULL_DUPLEX is used to decide if the iLO is to support full-duplex or half-
duplex mode. It is only applicable if SPEED_AUTOSELECT was set to "No."
The possible values are "Yes" or "No." It is case insensitive.
NIC_SPEED is used to set the transceiver speed if SPEED_AUTOSELECT was
set to "No." The possible values are "10" or "100." Any other values will result in
a syntax error.
DHCP_ENABLE is used to enable DHCP. The possible values are "Yes" or
"No." It is case insensitive.
IP_ADDRESS is used to select the IP address for the iLO if DHCP is not
enabled. If an empty string is entered, the current value is deleted.
SUBNET_MASK is used to select the subnet mask for the iLO if DHCP is not
enabled. If an empty string is entered, the current value is deleted.
GATEWAY_IP_ADDRESS is used to select the default gateway IP address for
the iLO if DHCP is not enabled. If an empty string is entered, the current value is
deleted.