Get_Diagport_Settings Return Messages; Mod_Diagport_Settings; Mod_Diagport_Settings Parameters - HP Integrated Lights-Out User Manual

314 User Guide Integrated Lights-Out

GET_DIAGPORT_SETTINGS Return Messages

A possible GET_DIAGPORT_SETTINGS return message is:

MOD_DIAGPORT_SETTINGS

The MOD_DIAGPORT_SETTINGS command is used modify the diagnostic
port network settings on iLO. For this command to parse correctly, the
MOD_DIAGPORT_SETTINGS command must appear within a RACK_INFO
command block, and RACK_INFO MODE must be set to write. The user must
have the configure iLO privilege to execute this command.
Example:

MOD_DIAGPORT_SETTINGS Parameters

All of the following parameters are optional. If a parameter is not specified, then
the parameter value for the specified setting is preserved.
<GET_DIAGPORT_SETTINGS>
<DP_SPEED_AUTOSELECT value="No"/>
<DP_NIC_SPEED value="100"/>
<DP_FULL_DUPLEX value="Yes"/>
<DP_IP_ADDRESS value="192.168.142.56"/>
<DP_SUBNET_MASK value="255.255.0.0"/>
</GET_DIAGPORT_SETTINGS >
<RIBCL VERSION="2.0">
<LOGIN USER_LOGIN="username" PASSWORD="password">
<RACK_INFO MODE="write">
<MOD_DIAGPORT_SETTINGS>
<DP_SPEED_AUTOSELECT value="No"/>
<DP_NIC_SPEED value="100"/>
<DP_FULL_DUPLEX value="Yes"/>
<DP_IP_ADDRESS value="192.168.142.56"/>
<DP_SUBNET_MASK value="255.255.0.0"/>
</MOD_DIAGPORT_SETTINGS>
</RACK_INFO>
</LOGIN>
</RIBCL>