HP Integrated Lights-Out User Manual page 102

102 User Guide Integrated Lights-Out
The server blade must be properly cabled for iLO connectivity. Connect to the
server blade with one of the following methods:
The BL p-Class tab enables you to control specific settings for the
ProLiant BL p-Class blade server rack. iLO also provides Web-based status for
the ProLiant BL p-Class server rack.
Through an existing network (in the rack)—This method requires you to
install the server blade in its enclosure and assign it an IP address manually
or using DHCP.
Through the server blade I/O port
In the rack—This method requires you to connect the local I/O cable to
the I/O port and a client PC. Using the static IP address listed on the I/O
cable label and the initial access information on the front of the server
blade, you can access the server blade with the iLO Advanced Remote
Console.
Out of the rack, with the diagnostic station—This method requires you to
power the server blade with the optional diagnostic station and connect
to an external computer using the static IP address and the local I/O
cable. For cabling instructions, refer to the documentation that ships with
the diagnostic station or to the Documentation CD.
Through the server blade rear panel connectors (out of the rack, with the
diagnostic station)—This method enables you to configure a server blade
out of the rack by powering the blade with the diagnostic station and
connecting to an existing network through a hub. The IP address is
assigned by a DHCP server on a network.
NOTE: The fourth Web page is available when a redundant power
management module is in the server configuration.