Resetting Ilo - HP Integrated Lights-Out User Manual

2. If SSL is operating correctly on the domain controller (a certificate is issued),
You can also use Microsoft® LDP tool to verify SSL connections. For more
information on the LDP tool, go to the Microsoft® website
(http://www.microsoft.com/support).
An old certificate can cause problems with SSL can on the domain controller
pointing when it points to a previously trusted CA with the same name, which is
rare but might happen if a certificate service is added and removed and then
added again on the domain controller. To remove old certificates and issue a new
one follow the instructions in Step 2.

Resetting iLO

In rare instances, it might be necessary to reset iLO; for example, if iLO is not
responding to the browser. To reset iLO, you must power down the server and
disconnect the power supplies completely.
iLO may reset itself in certain instances. For example, an internal iLO watchdog
timer resets if the firmware detects an iLO problem. If a firmware upgrade is
completed or a network setting is changed, iLO also resets.
The HP Management Agents 5.40 and later have the ability to reset iLO. To reset
iLO, select the Reset iLO option on the HP Management Agent Web page under
the iLO section.
you are prompted with a security message asking if you want to proceed with
accessing the site, or view the server's certificate. Clicking Yes does not
display a web page. This is normal. This process is automatic, but might
require rebooting. To avoid rebooting:
a. Open the MMC and add the certificates snap-in. When prompted, select
Computer Account for the type of certificates you want to view. Click
OK to return to the certificates snap in.
b. Select Personal>Certificates folder. Right-click the folder and select
Request New Certificate.
c. Verify Type is domain controller and click Next until a certificate is
used.
Troubleshooting iLO 395