Spanning Tree Commands; Bridge Stp Enable - SMC Networks 2552W-G2 User Manual

6
Command Line Interface

Spanning Tree Commands

The commands described in this section are used to set the MAC address table
aging time and spanning tree parameters for both the Ethernet and wireless
interfaces.
Command

bridge stp enable

bridge stp forwarding-delay
bridge stp hello-time
bridge stp max-age
bridge stp priority
bridge-link path-cost
bridge-link port-priority
show bridge stp
show bridge link
bridge stp enable
This command enables the Spanning Tree Protocol. Use the no form to disable the
Spanning Tree Protocol.
Syntax
bridge stp enable
no bridge stp enable
Default Setting
Enabled
Command Mode
Global Configuration
Example
This example globally enables the Spanning Tree Protocol.
Enterprise AP(config)bridge stp enable
Enterprise AP(config)
6-82
Table 6-15. Bridge Commands
Function
Enables the Spanning Tree feature
Configures the spanning tree bridge forward time
Configures the spanning tree bridge hello time
Configures the spanning tree bridge maximum age
Configures the spanning tree bridge priority
Configures the spanning tree path cost of a port
Configures the spanning tree priority of a port
Displays the global spanning tree settings
Displays current bridge settings for specified interfaces Exec
Mode Page
GC 6-82
GC 6-83
GC 6-83
GC 6-84
GC 6-84
IC 6-85
IC 6-85
Exec 6-86
6-80