Igmp Snooping Static Group Settings - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Rate Limit (1-1000)
Click the Apply button to accept the changes made. Click the Find button to locate a specific entry based on the information
entered. Click the Edit button to re-configure the specific entry. Enter a page number and click the Go button to navigate to a
specific page when multiple pages exist.

IGMP Snooping Static Group Settings

This window is used to view the Switch's IGMP Snooping Group Table. IGMP Snooping allows the Switch to read the Multicast
Group IP address and the corresponding MAC address from IGMP packets that pass through the Switch.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Static Group
Settings:
The following parameters can be configured:
Parameter
VLAN Name
VID List
IPv4 Address
Click the Find button to locate a specific entry based on the information entered. Click the Create button to add a new entry
based on the information entered. Click the Delete button to remove the specific entry based on the information entered. Click the
View All button to display all the existing entries. Click the Edit button to re-configure the specific entry. Enter a page number
and click the Go button to navigate to a specific page when multiple pages exist.
Click the Edit button to see thw following window.
Select the appropriate ports individually to include them in the IGMP snooping static group settings.
Click the Select All button to select all the ports for configuration. Click the Clear All button to unselect all the ports for
configuration. Click the Apply button to accept the changes made. Click the <<Back button to discard the changes made and
return to the previous page.
Enter the IGMP snooping rate limit used. By selecting the No Limit check box, the rate
limit for the entered port(s) will be ignored.
Figure 3 - 29. IGMP Snooping Static Group Settings window
Description
The VLAN name of the multicast group.
The VID list of the multicast group.
Enter the IPv4 address.
Figure 3 - 30. IGMP Snooping Static Group Settings – Edit window
73