D-Link xStack Reference Manual page 224

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
To remove a previously created rule, click the corresponding Delete Rules button. To add a new Access Rule, click the Add Rule
button:
The following parameters can be cconfigured:
Parameter Description
Access ID (1-200)
Type in a unique identifier number for this access. This value can be set from 1 to 200.
Auto Assign – Ticking this check box will instruct the Switch to automatically assign an Access ID
for the rule being created.
Action Select Permit to specify that the packets that match the access rule are forwarded by the Switch,
according to any additional rule added (see below).
Select Deny to specify that packets that match the access rule are not forwarded by the Switch
and will be filtered.
Select Mirror to specify that packets that match the access rule are mirrored to a port defined in
the config mirror port command. Port Mirroring must be enabled and a target port must be set.
Priority (0-7) Tick the corresponding check box if you want to re-write the 802.1p default priority of a packet to
the value entered in the Priority field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have its
incoming 802.1p user priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
Figure 7 - 14. Access Rule List window for IPv4
Figure 7 - 15. Add Access Rule window for IPv4
210