Lldp Port Settings - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Interval (5-3600)
Click Apply to implement the changes made.

LLDP Port Settings

This window is used to configure the LLDP port parameters.
To view the following window, click L2 Features > LLDP > LLDP > LLDP Port Settings:
The following parameters can be configured:
Parameter
From Port / To Port
Notification
Admin Status
Subtype
Action
receiver(s) when an LLDP change is detected in an advertisement received on the port
from an LLDP neighbor. To set the LLDP Notification Interval, enter a value between 5
and 3600 seconds.
Figure 3 - 74. LLDP Port Settings window
Description
Use the drop-down menus to select a range of ports to be configured.
Use the drop-down menu to enable or disable the status of the LLDP notification. This
function controls the SNMP trap however it cannot implement traps on SNMP when the
notification is disabled.
This function controls the local LLDP agent and allows it to send and receive LLDP frames on
the ports. This option contains TX, RX, TX And RX or Disabled.
TX - the local LLDP agent can only transmit LLDP frames.
RX - the local LLDP agent can only receive LLDP frames.
TX and RX - the local LLDP agent can both transmit and receive LLDP frames.
Disabled - the local LLDP agent can neither transmit nor receive LLDP frames.
The default value is TX And RX.
Use the drop-down menu to select the type of the IP address information will be sent.
Use the drop-down menu to enable or disable the action field.
104