Mac Address Table - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Parameter
VLAN Name
VID List (e.g.: 1, 4-6)
Port List (e.g.: 1, 3-5)
Group IPv4 Address
Click the Find button to locate a specific entry based on the information entered. Click the View All button to display all the
existing entries.
NOTE: To configure MLD snooping for the Switch, go to the L2 Features folder and
select MLD Snooping > MLD Snooping Settings.

MAC Address Table

This allows the Switch's dynamic MAC address forwarding table to be viewed. When the Switch learns an association between a
MAC address and a port number, it makes an entry into its forwarding table. These entries are then used to forward packets
through the Switch.
To view the following window, click Monitoring > MAC Address Table:
The following parameters can be configured:
Parameter Description
Port The port to which the MAC address below corresponds.
VLAN Name
Enter a VLAN Name for the forwarding table to be browsed by.
VID List
Enter a list of VLAN for the forwarding table to be browsed by.
MAC Address
Enter a MAC address for the forwarding table to be browsed by.
Security Tick the check box to diaplsy the FDB entries that are created by the security module.
Click the Find button to locate a specific entry based on the information entered. Click the Clear Dynamic Entries button to
delete all dynamic entries of the address table. Click the View All Entries button to display all the existing entries. Click the
Clear All Entries button to remove all the entries listed in the table. Click the Add to Static MAC table button to add the
Description
The VLAN Name of the multicast group.
The VLAN ID list of the multicast group.
Specify the port number(s) used to find a multicast group.
Enter the IPv4 address.
Figure 10 - 23. MAC Address Table window
269