Traffic Segmentation - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
The following parameters may be viewed or modified:
Parameter
LBD State
Mode
Trap Status
Interval (1-32767)
Recover Time (0 or 60-
1000000)
From Port / To Port
State
Click Apply to let the changes take effect.

Traffic Segmentation

Traffic segmentation is used to limit traffic flow from a single or group of ports, to a group of ports. This method of segmenting
the flow of traffic is similar to using VLANs to limit traffic, but is more restrictive. It provides a method of directing traffic that
does not increase the overhead of the Master switch CPU.
To view the following window, click Security > Traffic Segmentation:
To configure traffic segmentation on the Switch, first specify the Source Ports using the From and To drop-down menus at the top
of the window. Next, specify which ports on the Switch are able to receive packets from the port(s) specified in the first step.
Description
Use the drop-down menu to enable or disable loopback detection. The default is Disabled.
Use the drop-down menu to toggle between Port-based and VLAN-based.
Set the desired trap status: None, Loop Detected, Loop Cleared, or Both.
The time interval (in seconds) that the device will transmit all the CTP (Configuration Test
Protocol) packets to detect a loop-back event. The valid range is from 1 to 32767 seconds.
The default setting is 10 seconds.
Time allowed (in seconds) for recovery when a Loopback is detected. The Loopdetect
Recover Time can be set at 0 seconds, or 60 to 1000000 seconds. Entering 0 will disable
the Loopdetect Recover Time. The default is 60 seconds.
Use the drop-down menus to select a range of ports to be configured.
Use the drop-down menu to toggle between Enabled and Disabled.
Figure 6 - 80. Traffic Segmentation window
196