Ipv6 Route Settings; Ipv6 Neighbor Settings - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Link Status
Member Ports
NS Retransmit Time (0-
4294967295)
Automatic Link Local
Address
After making the desired changes, click the Apply button in the top section of the window.

IPv6 Route Settings

A static entry of an IPv6 address can be entered into the Switch's routing table for IPv6 formatted addresses.
To view the following window, click L3 Features > IPv6 Route Settings:
The following parameters can be configured:
Parameter
Interface Name
Nexthop Address
Metric (1-65535)
Click Apply to implement the changes made. Click Delete All to remove all the entries.

IPv6 Neighbor Settings

The user can configure the Switch's IPv6 neighbor settings. The Switch's current IPv6 neighbor settings will be displayed in the
table at the bottom of this window.
To view the following window, click L3 Features > IPv6 Neighbor Settings:
Displays whether the IPv6 Interface is Up or Down.
Displays the port numbers that are part of the IPv6 Interface.
Enter a value between 0 and 4294967295. This is the neighbor solicitation's retransmit
timer in milliseconds. The default is zero.
Toggle between Enabled and Disabled. Enabling this is helpful when no external source
of network addressing information is available.
Figure 4 - 5. IPv6 Route Settings Window
Description
The IP Interface where the static IPv6 route is created.
The corresponding IPv6 address for the next hop Gateway address in IPv6 format.
The metric of the IPv6 interface entered into the table representing the number of routers
between the Switch and the IPv6 address above. Metric values allowed are between 1 and
65535.
Figure 4 - 6. IPv6 Neighbor Settings Window
117