System Lan Leds; Booting - HP Integrity rx2660 User's & Service Manual

a. Turn off the server power button and unplug the AC power cords and any cables.
b. Re-seat all of the SAS disk drives installed in the server.
c. Reconnect the AC power cords and any cables. Restart the server to determine whether
the LEDs now become illuminated during the boot. If not, contact your reseller.
4. Use the EFI Shell info io command to check the SCSI drives.

System LAN LEDs

There are two system LAN LEDs on the rear bulkhead of the HP Integrity rx2660 server. These
LANs are connected to the system board.
System LAN LEDs
There are two 1 Gb LAN ports on the rear panel of the server. They are LAN 1 and LAN 2.
Table 60 Gb LAN 1 Connector LEDs
LED
Speed (left)
Link (right)
Table 61 Gb LAN 2 Connector LEDs on the Rear Panel
LED
Speed (left)
Link (right)

Booting

Table 62 Normal Boot Process LED States
Step System
Health
1 Off
2 Off
3 Off
4 Off
134 Troubleshooting
Description
Yellow: the 1000 MHz with Ethernet protocol is enabled
Green: the 100 MHz with Ethernet protocol is enabled
Off: no link
Green: link
Off: No link
Description
Yellow: the 1000 MHz with Ethernet protocol is enabled
Green: the 100 MHz with Ethernet protocol is enabled
Off: no link
Green: link
Off: No link
Internal External
Health Health
Off Off
Off Off
Off Off
Off Steady
green
Power System Insight
Display
Off Off
Steady Off
amber
Steady Off
green
Steady Off
green
Normal Power-Up Through OS
Boot
No AC power to the system.
System is shut down, but AC
power and standby power is
active.
System power rails are on
when power switch is toggled.
System power rails are on;
BMC drives external health
LED.