Installing A Sas Hard Drive; Removing A Sas Hard Drive Filler - HP Integrity rx2660 User's & Service Manual

The internal components are as follows:
System memory
Processors
PCIe/PCI-X cards
WARNING!
from the server prior to removing or installing server hardware (unless you are removing or
installing a hot-swappable or hot-pluggable component).
Voltages are present at various locations within the server whenever an AC power source is
connected. These voltages are present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to the equipment.

Installing a SAS Hard Drive

There are eight hot-pluggable SAS hard drive slots located on the front of the server. Slots without
SAS hard drives installed have slot fillers installed for cooling purposes.

Removing a SAS Hard Drive Filler

To install a SAS disk drive, you must first remove the hard drive filler.
1. Squeeze the tabs on the front of the filler to release it from the slot in the drive bay (1).
Ensure that the system is powered off and all power sources are disconnected
Installing Additional Components 43