Returning Damaged Equipment; Unloading The Server With A Lifter; Installing Additional Components; Introduction - HP Integrity rx2660 User's & Service Manual

NOTE: To identify each item by part number, refer to the sales order packing slip.

Returning Damaged Equipment

If the equipment is damaged, contact your HP customer service representative immediately. The
service representative initiates appropriate action through the transport carrier or the factory and
assists you in returning the equipment.

Unloading the Server With a Lifter

WARNING!
server, you must center the server on the lifter forks before lifting it off the pallet to avoid injury.
NOTE: HP recommends that you follow your local guidelines when lifting equipment.
To unload the server from the pallet using a lifter (if necessary):
1. Unpack the server.
2. Unroll the bottom corrugated tray corresponding to the side on which the lifter will be placed,
and slide the server as close to that edge of the pallet as possible.
3. Break off any foam packaging that can prevent the lifter from being fully inserted under the
server. Do not remove the foam packaging from the corners of the server. This foam is required
to elevate the server and to enable the forks of the lifter to be placed under the server.
4. Insert the lifter forks under the server.
5. Carefully roll the lifter forward until it is fully positioned against the side of the server.
6. Slowly raise the server off the pallet until it clears the pallet cushions.
7. Carefully roll the lifter and server away from the pallet. Do not raise the server any higher
than necessary when moving it over to the rack.

Installing Additional Components

This section describes how to install components into the server that are not factory-installed. If you
have additional components to install, be sure to install the additional components before installing
the server into your rack or pedestal configuration. Most servers are pre-configured with all
components installed prior to shipping from the HP factory.

Introduction

The rx2660 server contains external components (installable without removing the top cover), and
internal components that are accessed by removing the top cover.
The externally accessible components are as follows:
SAS hard drives
Power supplies
42 Installing the Server
Use caution when using a lifter. Because of the weight of the HP Integrity rx2660