Replacing The Fan / Display Board - HP Integrity rx2660 User's & Service Manual

Figure 62 Removing and Replacing the Fan / Display Board
Cables connected to the fan/display board
1
Captive thumbscrews
2
NOTE: Figure 62 (page 168)
is nearly identical.

Replacing the Fan / Display Board

To replace the fan/display board:
1. Align the connectors with the openings on the front bezel and place the fan/display board
onto the guide pins. Shuttle the board toward the front of the server until it locks into place (3).
2. Turn the knurled thumb screws clockwise until the board is secured into place (2).
3. Reconnect the five cables into the connectors on the fan/display board (1).
4. Replace the fan carrier. See
5. Replace the top cover. See
6. If rack mounted, slide the server completely into the rack. See
Rack" (page
168 Removing and Replacing Server Components
shows the Data Center fan/display board. The Office Friendly board
"Replacing the Fan Carrier Assembly" (page
"Replacing the Top Cover" (page
141).
Keyways on the fan/display board
3
Fan/display board
4
142).
"Inserting the Server into the
160).