Replacing The Front Bezel; Removing And Replacing The System Insight Display; Removing The System Insight Display - HP Integrity rx2660 User's & Service Manual

System Insight Display
1
power cable (disconnected
from fan/display board)

Replacing the Front Bezel

To replace the front bezel:
1. Guide the power connector on the System Insight Display through the hole in the server chassis.
See Figure
2. Align the bezel slots with the tabs on the server, and rotate the bezel downward and gently
push it into place so it is flush with the front server wall.
3. Replace the screws that attaches the bezel to the server.
4. Connect the System Insight Display power cable to the fan/display board.
5. Replace the fan carrier into the server. See
6. Replace the system fans. See
7. Replace the top cover. See
8. If rack mounted, slide the server completely into the rack. See
Rack" (page
9. Reconnect the power cables and power on the server. See
the Server" (page

Removing and Replacing the System Insight Display

The System Insight Display is located in the front of the server and is attached to the front bezel.
WARNING!
the server prior to performing this procedure.
Voltages are present at various locations in the server whenever an AC power source is connected.
These voltages are present even when the main power switch is off.
Failure to observe this warning can result in personal injury or equipment damage.
CAUTION:
ESD safety precautions can result in damage to the server.

Removing the System Insight Display

To remove the System Insight Display:
1. Power off the server and disconnect the power cables. See
the Server" (page
2. If rack mounted, slide the server completely out from the rack. See
the Rack" (page
3. Remove the top cover. See
4. Remove the front fan carrier assembly. See
5. Disconnect the System Insight Display power cable from the fan/display board.
6. Remove the front bezel from the server. See
7. Push on the two plastic clips that hold the System Insight Display to the bezel (1) and push the
System Insight Display through the front of the bezel.
156 Removing and Replacing Server Components
2
53.
"Replacing a Server Fan " (page
"Replacing the Top Cover" (page
141).
77).
Ensure that the system is powered off and all power sources are disconnected from
Observe all ESD safety precautions before attempting this procedure. Failure to follow
77).
141).
"Removing the Top Cover" (page
T- 1 0 bezel screw location
"Replacing the Fan Carrier Assembly" (page
"Removing the Fan Carrier Assembly" (page
"Removing the Front Bezel" (page 155)
149).
142).
"Inserting the Server into the
"Powering On and Powering Off
"Powering On and Powering Off
"Extending the Server from
142).
160).
158).