HP Integrity rx2660 User's & Service Manual page 54

Figure 23 ZIF Socket Unlocked
CAUTION:
processor install tool. The counterclockwise 180 degree rotation (half turn) unlocks the socket.
A clockwise 180 degree rotation locks the socket. Attempting to turn the locking mechanism
more than 180 degrees can severely damage the socket.
8. Remove any protective packaging from the processor.
NOTE:
use.
9. Inspect the processor pins to verify the pins are not bent.
10. Align the alignment holes on the processor with the alignment posts on the processor cage,
and carefully lower the processor onto the processor socket.
alignment holes and posts on the processor and system board.
CAUTION:
pins seat into the socket. No additional pressure is required. Damage to the pins can occur
if pressure is applied.
1 1. Lock the processor into the socket on the processor board.
a. Remove the processor install tool (2.5 mm driver) from the tool holder on the airflow
guide.
b. Insert the processor tool into the hole that runs down the side of the heatsink.
c. Rotate the processor tool clockwise 180 degrees to lock the ZIF socket.
d. Refasten the processor install tool (2.5 mm driver) to the tool holder on the airflow guide.
12. Connect the processor power cable into the connector cable that attaches directly to the system
board.
54 Installing the Server
The ZIF socket for the processor is locked and unlocked by half a full turn of the
Protective covers are installed to protect connector pins. Save these covers for future
Do not press the processor into the socket. When properly aligned, the processor
Figure 22 (page 53) shows the