Conconfig; Syntax; Parameters; Notes - HP Integrity rx2660 User's & Service Manual

Example 10 ioconfig command
Shell> ioconfig
Deconfigure or reconfigure IO components or settings
IOCONFIG [fast_init|wol [on|off]]
fast_init
mps_optimie Specifies PCIe optimization setting
wol
on|off
Note:
1. If fast_init is enabled, firmware will connect only the minimum set of
devices during boot.
feature if failure occurs.
2. A reboot is required for PCIe MPS sptimiation changes to take effect
3. Any pending Wake-On-LAN request will not be cleared until reboot if
the setting is changed to disabled.
System will clear pending Wake-On-LAN requests each time the system
reboots if the setting is disabled.
Examples:
* To display the current settings
fs0:\> ioconfig
Fast initialization: Enabled
MPS optimization:
System Wake-On-LAN: Disabled
* To display the current device connection policy setting
fs0:\> ioconfig fast_init
Fast initialization: Enabled
* To disable fast initialization
fs0:\> ioconfig fast_init off
Fast initialization: Disabled
* To enable the System Wake-On-LAN setting
fs0:\> ioconfig wol on
System Wake-On-LAN: Enabled

conconfig

Configures the primary console and turns on other consoles for mirroring from the firmware.

Syntax

conconfig [index][on|off|primary]

Parameters

Index Specifies index of console to set as primary
on Enables the specified console as a secondary console
off Puts console into "Not Configured" (NC) state
primary Sets the specified console as primary

Notes

Primary console setting takes effect after reboot.
P in the status column indicates that the console is the primary.
S in the status column indicates that the console is the secondary.
NC in the status column indicates that the console is not configured.
If a disabled console is set to primary, it is enabled.
222 Utilities
Specifies device connection policy setting
Specifies System Wake-On-LAN setting
Specifies to configure or deconfigure a feature or component
This feature might cause boot failure; disable this
Disabled