HP Integrity rx2660 User's & Service Manual page 199

1. Insert the new system board with the back of the system board going into the server first.
Guide the system board onto the guide pins, and slide the system board into the keyways.
NOTE: When replacing the system board you are prompted to copy the secondary UUID
to the primary location (SEC to PRI). Reply y. (
2. Reconnect the cables that attach to the system board (1). See
3. Replace the I/O fan carrier. See
4. Reconnect the power cable that attaches to the SAS backplane.
5. Replace the Smart Array P400 controller backplane and PCIe expansion card (if necessary).
6. Reconnect the power cable that attaches to the Smart Array P400 controller backplane and
the PCIe expansion card (if necessary).
7. Reconnect the internal SAS cables.
CAUTION: When reconnecting the SAS cables, match each cable with the appropriate
socket on the SAS core I/O card. If the cables are mismatched, the server might not reboot.
Both cables and sockets are clearly marked with the correct channel.
NOTE: The cables connect directly to the system board for a non-RAID configuration, and
connect to the Smart Array P400 controller for a RAID configuration.
8. Replace the TPM. See
9. Replace the I/O card cage.
10. Replace the power supply cage. See
1 1. Replace the processors. See
12. Replace the memory. See
13. Replace the airflow guide. See
14. Replace the fan carrier assembly.
15. Replace the top cover. See
16. If rack mounted, slide the server completely into the rack. See
Rack" (page 141).
17. Reconnect all cables and power on the server. See
Server" (page 77).
18. Restore boot, LAN, and iLO 2 MP settings recorded in step
"Removing the System Board" (page 196)
"Replacing the I/O Fan Carrier Assembly" (page
"Replacing the TPM" (page
"Replacing the I/O Backplane Assembly" (page
"Replacing the Power Supply Housing" (page
"Installing a Processor" (page
"Installing Memory" (page
"Replacing the Airflow Guide" (page
"Replacing the Fan Carrier Assembly" (page
"Replacing the Top Cover" (page
when prompted by the server.
Figure 85.
187).
176).
170).
145).
142).
"Inserting the Server into the
"Powering On and Powering Off the
Step 1 of the procedure, see
Removing and Replacing the System Board 199
163).
165).
179).
160).