Replacing A Sas Hard Drive - HP Integrity rx2660 User's & Service Manual

3. Gently slide the hot-pluggable hard drive out of the server (3).
Figure 49 Removing a Hot-Pluggable Hard Drive
NOTE: For cooling purposes, always leave hard drive fillers in empty drive slots.

Replacing a SAS Hard Drive

To install a SAS hard drive:
NOTE: Load the SAS hard drives in order, starting with number 8, working from right to left.
1. Remove the SAS hard drive filler if required. See
NOTE:
hard drive fillers in empty drive slots.
2. Insert the SAS hard drive into the slot guides, and slide the drive into the slot until it seats into
the socket on the disk backplane (1). See
3. Close the drive-ejector handle by pushing it down until it clicks into place (2).
Figure 50 Replacing a SAS Hard Drive
Save the SAS hard drive filler for future use. For cooling purposes, always place
"Removing a Hard Drive Filler" (page
Figure 50 (page 153)
Removing and Replacing a Hot-Pluggable SAS Hard Drive 153
for installation procedures.
151).