Replacing The Battery On System Boards With Edc < 4739; Installing The Battery Clip - HP Integrity rx2660 User's & Service Manual

3. Insert a flat tool under the battery retaining clip and carefully push it away from the battery.
Lift the battery from the socket.
Figure 72 System and iLO 2 MP Battery Locations
System battery
1
Replacing the Battery on System Boards with EDC < 4739
To replace the system or iLO 2 MP battery in the socket:
1. Insert the replacement battery into the socket on the system board.
NOTE:
2. Replace the top cover. See
3. Reconnect the power cables and power on the server. See
the Server" (page
4. Restore the boot, LAN and iLO 2 MP settings using the method you used to back them up.
5. Reset the server date and time using the EFI date and time commands.

Installing the Battery Clip

The battery clip installs ONLY on servers that contain system boards with EDC less than 4739.
System boards with an EDC of 4739 and later DO NOT require the battery clip and will not work
with the battery clip.
To determine if your system has an Engineering Date Code (EDC) earlier than 4739, and thus is
a candidate for installing the battery clip, run the Display FRU (DF) command from the iLO 2 MP
to obtain the FRUID. If the second Custom Info field in the FRUID is earlier than 4739 (see
(page 182)), your system is a candidate for the battery clip.
To order the battery clip, use part number AB419-3400A. Ordering a quantity of 1 will provide
two battery clips.
iLO 2 MP battery
2
The positive terminal of the battery is designated by the + sign.
"Replacing the Top Cover" (page
77).
142).
"Powering On and Powering Off
Removing and Replacing the System or iLO 2 MP Battery 183
Example 1