Error Messages - Brother DCP-9010CN Service Manual

2.2

Error Messages

The error messages displayed on the LCD of the product and their description and measure
are shown in the table below.
Error message
Access Error
(USB direct interface
model only)
Belt End Soon
Calibrate
Scroll message:
Calibration failed.
See
Troubleshooting
chapter in User's
guide.
Cartridge Error
Cooling Down Wait
for a while
Comm. Error
Connection Fail
Cover is Open
Disconnected
Document Jam
DR Mode is Use
Drum End Soon
(X) *
or
Drums End Soon
Drum Error
Fuser Error
* (X) at the end of the message shows the color of the toner cartridge or drum unit.
(X) must be either K (Black), Y (Yellow), M (Magenta) or C (Cyan).
Description/Measure
The USB device was removed while data was
processing. Press Job Cancel button. Reinsert the
USB device and try to print with Direct Print or PictBridge.
The belt unit is near the end of its life. Buy a new belt
unit before you get a "Replace Belt" message.
- Turn off the machine. Wait a few seconds and turn it
on again.
- Put in a new drum unit.
- Put in a new belt unit.
- Put in a new waste toner box.
Take out the drum unit and toner cartridge assembly for
the toner color that is indicated on the LCD. Remove the
toner cartridge from the drum unit and install a new toner
cartridge in the drum unit. Put the drum unit and toner
cartridge assembly back into the machine again.
The temperature of the drum unit or toner cartridge is too
hot.
Poor telephone line quality caused a communication error.
You tried to poll a fax machine that is not in polled waiting
mode.
Close the cover that is indicated on the LCD.
The other person or other person's fax machine stopped
the call.
The document was not inserted, or fed properly.
The machine is set to Distinctive Ring mode.
The drum unit is near the end of its life. Buy a new toner
cartridge that is indicated on the LCD before you get a
"Replace Drum" message.
Clean the corona wires. If the LCD still shows the same
error message after you have cleaned the corona wire,
replace the drum unit with a new one that is indicated on
the LCD.
Turn off the power switch, wait a few seconds and then
turn it on again. Leave the machine for 15 minutes with
the power on.
3-8
Refer to:
3-48
3-27
3-31
3-36
3-56
3-46
3-32
3-88
3-96
3-25
3-38
3-42
3-96
3-42
3-101
3-98
3-24
3-14
3-32
3-25
3-50
Confidential