Fuser/Eject Drive Motor Sensor Pcb Assy - Brother DCP-9010CN Service Manual

8.70 Fuser/Eject Drive Motor Sensor PCB ASSY

(1) Remove the three Taptite bind B M4x12 screws, and then remove the Eject gear cover
from the Side frame L.
Side frame L
Note:
Be careful when changing the setup condition of the main body with the left side up while
the Eject gear cover is removed because the gear may fall off.
(2) Release the Hook to remove the Fuser/eject drive motor sensor PCB ASSY from the
Eject gear cover.
Harness routing: Refer to
Taptite bind B M4x12
Hook
Taptite bind B M4x12
Fig. 5-206
2b
2a
Hook
Fig. 5-207
" Fuser/Eject Drive Motor, Fuser/Eject Drive Motor Sensor PCB
ASSY."
5-165
Eject gear cover
Fuser/eject drive motor sensor PCB ASSY
Eject gear cover
Hook
Confidential