Brother DCP-9010CN Service Manual page 542

- Selectors 5 and 6: Busy tone detection in automatic sending mode
These selectors determine whether or not the machine automatically disconnects a line upon
detection of a busy tone in automatic sending mode.
Setting selector 6 to "0" ignores a busy tone so that the machine does not disconnect the line.
Setting selectors 5 and 6 to "0" and "1," respectively, makes the machine detect a busy tone only
after dialing and disconnect the line.
Setting both of selectors 5 and 6 to "1" makes the machine detect a busy tone before and after
dialing and then disconnect the line.
- Selector 7: Busy tone detection in automatic receiving mode
This selector determines whether or not the machine automatically disconnects the line upon
detection of a busy tone in automatic receiving mode.
WSW06 (Redial/Pause button setting and 2nd dial tone detection)
■
Selector No.
1
Redial/Pause button setting and 2nd
l
dial tone detection
3
4
l Detection of 2nd dial tone
6
7 No. of 2nd dial tone detection cycles
Allowable instantaneous interrupt
8
during reception of 2nd dial tone
Note:
Selectors 4 through 8 are not applicable in those countries where no dial tone detection is
supported, e.g., USA.
Function
App.1-9
Setting and Specifications
No. 1 2 3
0 0 0: No pause
0 0 1: 3.5 sec. wait
0 1 0: 7 sec. wait
0 1 1: 10.5 sec. wait
1 0 0: 2.8 sec. wait
1 0 1: 2nd dial tone detection both
in DP and push-button (PB)
dialing system
1 1 0: 2nd dial tone detection only in
pulse dialing (DP) system
1 1 1: 2nd dial tone detection both in
DP and push-button (PB)
dialing system
No. 4 5 6
0 0 0: 50 ms
0 0 1: 250 ms
0 1 0: 500 ms
0 1 1: 620 ms
1 0 0: 800 ms
1 0 1: 1.5 sec.
1 1 0: 2.0 sec.
1 1 1: 2.5 sec.
0: 1 cycle
1: 2 cycles
0: 30 ms
1: 50 ms
Confidential