Error Code 25; Error Code 26; Error Code 29 - Brother DCP-9010CN Service Manual

■ Error code 25

Print Unable 25
Turn the power off and then back on again.
Develop drive motor error (Incorrect synchronized signal of the develop drive motor)

Error code 26

Print Unable 26
Turn the power off and then back on again.
Belt drive motor error
Error code 28
Print Unable 28
Turn the power off and then back on again.
Drum drive motor error (Incorrect synchronized signal of the drum drive motor)

Error code 29

Print Unable 29
Turn the power off and then back on again.
Belt cleaner drive motor error (Incorrect synchronized signal of the belt cleaner drive motor)
Step
1 Harness connection failure of
motor
2 Motor failure
3 Engine PCB failure
4 Main PCB failure
5 Low-voltage power supply PCB
failure
Cause
3-16
Remedy
Check the harness connection of the
appropriate motor and reconnect it.
Replace the appropriate motor.
Replace the engine PCB ASSY.
Replace the main PCB ASSY.
Replace the low-voltage power supply
PCB ASSY.
Confidential