Registration Sensor Holder Assy - Brother DCP-9010CN Service Manual

8.83 Registration Sensor Holder ASSY

(1) Remove the Taptite cup S M3x6 SR screw from the Registration sensor holder ASSY.
<Left side>
(2) Wire the harness and release the Hook. Slide the Registration sensor holder ASSY in the
direction of the arrow 2a, and remove it from the Registration sensor plate.
<A view>
Registration sensor plate
Assembling Note:
- Be careful not to place the harness between the Registration sensor holder ASSY and the
Registration sensor plate when assembling the Registration sensor holder ASSY to the
Registration sensor plate.
- A reinforcement plate for transportation is assembled to the Registration sensor holder
ASSY (service part). Remove the reinforcement plate for transportation from the
Registration sensor holder ASSY before assembling.
Harness routing: Refer to
Taptite cup S M3x6 SR
Registration sensor holder ASSY
Fig. 5-244
2a
A view
Hook
<Left side>
Fig. 5-245
" Registration Sensor Holder ASSY."
5-188
<Right side>
Registration sensor holder ASSY
2b
2a
Registration sensor plate
<Right side>
Confidential