Periodical Maintenance Parts - Brother DCP-9010CN Service Manual

3.

PERIODICAL MAINTENANCE PARTS

3.1 Periodical Maintenance Parts
Periodical maintenance parts are the parts to be replaced periodically to maintain product
quality. These parts would affect the product quality if they loose their functionality even if they
do not appear to be damaged or there is no change in their appearance.
The periodical maintenance parts listed in the table below should be replaced according to the
service life.
Parts name
Fuser unit
Paper feeding kit
* The paper feeding kit includes the separation pad ASSY, pad spring and roller holder ASSY.
When replacing the periodical maintenance parts, each of the counters need to be reset in
order to record the number of replacement times.
(Refer to "2.1 Resetting the Periodical Maintenance Parts Life" in
The number of print pages of the machine can be checked in the log information display
(maintenance mode 80). (Refer to
The actual number of printed page will vary depending on the type of print job or the paper to
being used. The figures indicated as the approximate life in the table above are worked out
when printing a general business document (in accordance with ISO/IEC 19798) on A4-size
paper.
Note:
- Always turn off the power switch of the machine and unplug the power cord from the
power outlet before replacing the periodical maintenance parts.
- If the fuser unit is replaced after an error related to the fuser unit occurs, you need to wait
until the machine sufficiently cools down before replacing the unit. After replacing the
unit, turn ON the machine and leave it for approximately fifteen minutes. This will make
the machine to be released from the error.
LCD
Replace Fuser
*
Replace PF Kit
"1.4.27 Display of the machine's log" in Chapter
4-3
Replacement
Approximate life
50,000 pages Refer to
50,000 pages Refer to
Chapter7.)
procedure
3.2.1
3.2.2
7.)
Confidential