Brother DCP-9010CN Service Manual page 282

(3) Remove the three Taptite cup S M3x6 SR screws, and then remove the USB direct
interface FG harness ASSY and Main shield cover plate ASSY.
Taptite cup S M3x6 SR
Main shield cover plate ASSY
USB direct interface FG harness ASSY
Taptite cup S M3x6 SR
Note:
After removing the Main shield cover plate ASSY, do not set up the main body with the left
side down. The machine may get damaged due to load applied to the paper feed motor.
(4) Disconnect the five Connectors (CN16, CN14, CN13, CN11, CN8) from the Main PCB ASSY.
(5) Remove the three Taptite cup S M3x6 SR screws, and then remove the FB FG harness
ASSY, ADF FG harness ASSY and NCU FG harness ASSY 2 from the Main PCB shield plate.
CN27
Assembling Note:
Place the Harness of the Connectors (CN16 and CN14) at the front when assembling the
Connectors (CN16, CN14, CN13, CN11, and CN8) to the Main PCB ASSY.
Hook
Hook
Fig. 5-34
FB FG harness ASSY (Taptite cup S M3x6 SR)
NCU FG harness ASSY 2
(Taptite cup S M3x6 SR)
Main PCB ASSY
CN24 CN18 CN16 CN14 CN13 CN11 CN8
CN20
CN17
CN26
CN19
CN23
CN22
Fig. 5-35
5-55
Main body
<Left side>
ADF FG harness ASSY
(Taptite cup S M3x6 SR)
Main PCB shield plate
CN6
CN1
CN2
CN3
CN5
CN15
CN10
Hook
Confidential