Document Scanner Unit - Brother DCP-9010CN Service Manual

8.26 Document Scanner Unit

(1) Remove the four Taptite cup B M3x10 screws (2 each at upper and lower sides) of the
Panel unit, and then lift the Panel unit.
Note:
Do not pull the Panel unit strongly because a Harness is connected.
Panel unit
(2) Gently lift up the Panel unit slightly from the Document scanner unit and disconnect the
Connector (CN1) from the Panel PCB ASSY.
Harness routing: Refer to
Taptite cup B M3x10
CN1
Panel PCB ASSY
" Panel Unit."
Taptite cup B M3x10
Fig. 5-68
Document scanner unit
Fig. 5-69
5-78
Document scanner unit
Panel unit
Confidential