Telneting to media server
Enabling alarms uses Linux commands through Telnet.
1
Click Start > Run to open the Run dialog box
2
Type
telnet 192.11.13.6
3
Log in as
Enabling alarms
To INADS via modem
NOTE:
These steps must be done on both media servers.
1
Type
almenable -d b
2
Type
almenable
To INADS via SNMP
NOTE:
Do these steps only if a Secure Service Gateway (SSG) is being installed.
NOTE:
These steps must be done on both media servers.
1
Type
almsnmpconf -d ipaddress -c communityname
trap receiver address for the SSG device and communityname is the community string name
required by the SSG device.
2
Type
almsnmpconf
Verify that the correct information was entered.
3
At the prompt, type
4
Type
almenable
Verify that the SNMP alarm origination is enabled. If used, verify that alarm origination via
modem is still enabled.
5
Log off.
To INADS on second server
1
Connect to the second media server
2
Repeat
Telneting to media server
server.
Installing and Configuring the Avaya S8700 or S8710 Media Server
June 2004
and press Enter.
craft
or
dadmin
(if business partner).
and press Enter
and press Enter to verify that the alarms are enable
and press Enter.
almenable -s y
and press Enter.
and press Enter.
on page 65 through
Completing the installation administration
.
and press Enter, where ipaddress is the
Enabling alarms
Telneting to media server
d.
on page 65 on the second
65
5