8
To recall copy program
Follow the procedure below to recall the stored copy program. The job
settings can be checked before recalling them.
0 The job settings cannot be changed from the Check Job Screen. If any
setting change is desired, recall the copy program then access the
desired setting screen, or press [Mode Check] to jump to the desired
setting from the Mode Check Screen. For details, see "Checking Feature
Selections before Copying (Mode Check)" on page 8-6.
1
Position the original.
2
Press [Mode Memory] on the control
panel.
The Recall Copy Program Screen will
be displayed.
3
Touch the desired copy program key to highlight it.
–
To recall the program without checking job settings, proceed to
step 8.
8-14
Advanced Information
bizhub 500/420/360 (Phase 3)