Konica Minolta BIZHUB 360 User Manual page 702

16
– Touch [Test Copy].
The Test Copy Screen will be displayed.
– Press [Start] to make a sample copy. When completed, touch
[Close] to return to the Punch Horizontal Position Screen.
– Check the hole positions of the sample copy. Change the
adjustment value if satisfactory result is not obtained.
Touch [+] to increase the adjustment value for shifting the hole
positions to the right. (Range: 0.5 mm ~ 5.0 mm)
Contrary, touch [–] if it is off to the left. (Range: –0.5 mm ~ –5.0 mm)
– Repeat this procedure until a satisfactory result is obtained.
6
Adjust the Punch Resist Loop Size, i.e., the slanted punch position in
double-sided copies or in cover sheet, referring to a sample copy made
by using Punch mode.
– Touch [4 Punch Resist Loop Size] to display the Punch Resist Loop
Size Screen.
– Select the menu item to be adjusted, then touch [Test Copy].
The Test Copy Screen will be displayed.
16-80
Utility <Administrator Setting>
bizhub 500/420/360 (Phase 3)