Table of Contents
Advertisement
HOME
To Do This
Enter numbers
Enter spaces
Enter hyphens (-)
Enter pauses (i.e., to wait for
long distance or outside lines)
Add a switch from pulse
to tone dialing for part
of the call
Move the cursor to
make corrections
6
Press the Start key to enter the number.
7
Enter the Location ID. This is a descriptive title up
to 16 characters long. Refer to the instructions
below.
To Do This
Enter numbers
Enter spaces
Enter hyphens (-)
Enter alphabet characters
Enter a unique character
Enter two successive
numbers on
the same key.
Move the cursor to
make corrections
Use
Numeric keypad (press once)
14/Space One Touch key
Hyphen key
15/Pause One Touch key
*/Tone key
Yes 3and No 4 keys
Use
Numeric keypad (press once)
Space One Touch key
Hyphen key
Locate the character you want on the numeric key
pad. Press that key repeatedly until the character
appears in the display.
Press the 0/Unique key repeatedly until the character
you want appears in the display. The following char
acters are available: ! # & ' ( ) * + , - . / : ; = ? · ä ß ñ ö
ü Æ Å Ø æ å ø.
Press the No 4 key to move to the next
letters/
character.
Yes 3 and No 4 keys
8
Press the Start key. The display shows
NO=<OR LOCATION> for about three seconds.
9
Enter the optional alternate fax number, if desired.
Refer to the instructions following Step 5.
10 Press the Start key to finish programming the
One Touch key. The display shows LOCATION
PROGRAMMING.
11 To continue programming One Touch keys, go
back to Step 3. If you are finished programming,
press the Select Function key.
12 Lift off the plastic cover above the One Touch
label. Using a pencil, write in the location name for
your One Touch key(s). Then replace the cover.
If you are experiencing problems communicating
with a remote location in a very noisy telephone
area, set up a One Touch key for that location and
try turning Echo Protection on for that One Touch
key. This helps the machine overcome noise and
echo problems on the phone line.
See the Problem Checklist sections for other
suggestions.
1
Press the Select Function key.
2
Press the 9/User Program One Touch key.
The display shows 1:FUNC. PROGRAMMING.
Advertisement
Table of Contents
