Konica Minolta FAX 9820 User Manual page 7

I n s t a l l a t i o n H i n t s I n s t a l l a t i o n H i n t s I n s t a l l a t i o n H i n t s I n s t a l l a t i o n H i n t s I n s t a l l a t i o n H i n t s
Install your Konica FAX 9820 in a dust-free location away from direct sunlight.
Do not plug your machine into a power source shared by equipment
which produces electrical noise (i.e., air conditioners, etc.).
Leave electronic adjustments to authorized service personnel.
The LINE terminal connects your fax machine to a standard
telephone line. To avoid damage to your telephone system or to the
unit, do not plug your fax machine into anything other than a
standard RJ-11C jack.
Your machine is intended to be grounded electrically and is equipped
with a three-wire grounded power cord. For your safety, do not
attempt to defeat your power cord's grounding plug.
The power outlet should be located near the equipment and should
be easily accessible.
The TEL port on the back of the unit is only suitable for 2-wire
devices. Not all standard telephones will respond to incoming ringing
when connected to an extension socket.
This equipment may not necessarily provide for the effective hand-
over of a call from a telephone connected to the same line.
Operation and Maintenance
Use a dry cloth to clean the control panel and the main body of the unit.
Aside from replacing the toner and image drum cartridge, do
not disassemble or attempt to service this unit yourself.
Refer to a qualified service agent.
Pull out the AC plug before trying to remove any objects that may
have fallen into the machine.
If the unit becomes physically damaged, disconnect the power cord
immediately and arrange for its repair or disposal.
When relocating your Konica FAX 9820, always disconnect the
telephone line before disconnecting the power cord, then reconnect
the power cord first.
This unit is not intended to be used in parallel with any other
telephone devices.
HOME