Setting Distinctive Ring - Konica Minolta FAX 9820 User Manual

HOME
programming, the new default combinations
appear on the lights above the Yes 3 and the
No 3 keys. The default is STD/NORMAL.
10 T/F TIMER PROG.: When set to the telephone/
fax answering mode, your machine automatically
distinguishes between incoming voice and fax calls.
If the incoming call is a voice call, machine rings to
tell you to pick up the handset. If you do not
answer, the machine automatically switches back to
facsimile mode to allow the calling party to send a
fax. The T/F TIMER function controls how long it
waits before switching back to fax mode. Available
settings are 20 SECONDS or 35 SECONDS (default).
11 RING RESPONSE: This function controls how long
your machine waits before answering an incoming telephone
call. The available settings are 1 RING (default), 5 SECONDS,
10 SECONDS, 15 SECONDS, or 20 SECONDS.
Note: At the default 1-ring setting, your Konica Fax
answers calls immediately, and you will not hear any
ring. If you need to hear the ring, change to one of the
other settings.
12 DISTINCTIVE RING: Distinctive ringing is a
service offered by some telephone carriers. It lets
you have different numbers on one line, each with
its own distinctive ring. You can then use one
number exclusively as a fax number without the
expense of a second line. (Your local telephone
carrier can provide you with more information
about this service, which usually has an additional
charge.) To use this function, refer to Setting Your
Fax Machine's Ring Pattern below. Available set-
tings are OFF (default) and ON.
Notes:
You must have your local telephone carrier's
Distinctive Ring service.
Your machine must be in FAX or PC answer
mode, and the PBX dial parameter must be set to OFF.
Other modes—TEL, TEL/FAX, or TAD—will override
Distinctive Ring.
This feature may not work properly if you have a
telephone other than a genuine Konica optional
handset connected to your machine.
To set up your machine to recognize another ring
pattern:
1 Press the Select Function key.
2 Press the 9/User Program One Touch key.
The display shows 1:FUNC. PROGRAMMING.
3 Press the Yes 3 key. The display shows
FUNCTION NO. [ ].
4 Using the numeric keypad, enter 12. The