Table of Contents
Advertisement
HOME
To program your Fax ID:
1
Press the Select Function key.
2
Press the 9/User Program One Touch key. The
display shows 1:FUNC. PROGRAMMING.
3
On the numeric keypad, press 4. The display
shows 4:SYSTEM DATA PRG.
4
Press the Yes § key. The display shows NO=<TSI/
CSI>, ID=<SENDER ID>.
5
After the display clears, enter the full telephone
number of your machine using the numeric
keypad.
Note: use the Hyphen key to enter a "+" character for
international numbers, and use the Space One Touch
key to enter spaces.
6
Press the Start key to save your entry.
7
Enter your Sender ID. This is a descriptive title up
to 32 characters long. Refer to the instructions
below.
To Do This
Use
Enter numbers
Numeric keypad (press once)
Enter spaces
14/Space One Touch key
Enter hyphens
Hyphen key
Enter alphabet characters
Locate the character you want on the
numeric keypad. Press that key
repeatedly until the character appears on
the display
Enter a unique character
Press the 0/Unique key repeatedly until
the character you want appears on the
display. The following characters are
available: ! # & ' ( ) * + , - . / : ; = ? · ä ß
ñ ö ü Æ Å Ø æ å ø
Press the No 4 key to move to the
Enter two successive
letters/numbers using
next character
the same key
Yes 3 and No 4 keys
Move the cursor to
make corrections
8
Press the Start key to save your entry. The
display shows NO=<CALL BACK NO.>.
9
After the display clears, use the numeric keypad
to enter the telephone number for call back
messages. Enter up to 20 characters.
Tip: Use the 14/Space One Touch key to enter spaces.
10 Press the Start key to save your entry.
11 Press the Select Function key to finish.
Advertisement
Table of Contents
