Konica Minolta FAX 9820 User Manual page 71

HOME
to specify the size of the paper you are using in
the optional second paper tray, and only appears
if that option is installed. See setting 13 for de-
tails.
15 USER LANGUAGE: This function allows you
to switch between the two languages programmed
into your machine. Available settings are ENG.
(English, the default) and SPA. (Spanish), FRE.
(French), or POR. (Portuguese), depending on
where you purchased your machine.
16 INCOMING RING: This function controls the
telephone ringing sound your machine makes
when a call comes in. When set to off, it does not
ring during incoming calls. The available settings
are:
ON (default): Only rings when set to Manual
Receive [TEL] mode or when the RING
RESPONSE function is set to 5, 10, or 20
seconds.
OFF: Does not ring when a call comes in.
DRC (distinctive ring cancel): Rings for each
incoming call with the same tone, even if you
have set function setting 12, DISCTINCTIVE
RING to on.
17 REMOTE RECEIVE: This function lets you
use an attached phone to tell your machine to switch
from telephone to fax mode so it can receive an in-
coming fax. Use the keypad of an external telephone
to enter the remote receive number you have pro-
grammed into your machine.
In addition, if your machine is in TAD mode (see page
22), a caller can enter the programmed remote re-
ceive number after leaving a voice message; this en-
ables the machine to receive a fax from the caller.
Available settings are OFF (default), 00, 11, 22, 33,
44, 55, 66, 77, 88, 99, **, and ##.
18 MEM./FEEDER SW.: This function controls the
way your machine normally transmits fax messages:
by scanning the document into memory first, or by
transmitting directly from the document feeder. Avail-
able settings are FEEDER and MEMORY (default for
the 9820).
Note: If you are using the MEMORY setting and you send
a large number of faxes in one session, you may
encounter a MEM OVERFLOW error message. If this
occurs often, you can correct the problem either by
adding an optional memory upgrade or by changing to
the FEEDER setting.
19 NOT USED