Konica Minolta FAX 9820 User Manual page 3

Federal Communications Commission
Requirements for End Users
This device has been granted a registration number by the
Federal Communications Commission, under Part 68 rules and
regulations for direct connection to the telephone lines. In order
to comply with these FCC rules, the following instructions must
be carefully read and applicable portions followed completely.
1. This equipment complies with Part 68 of FCC rules. On the
bottom of the equipment is a label that contains, among
other information, the FCC registration number and ringer
equivalence number (REN) for this equipment. If requested,
this information must be provided to the telephone com-
pany.
2. The following USOC jacks may be used with this equip-
ment: RJ11C.
3. The REN is used to determine the quantity of devices that
may be connected to the telephone line. Excessive REN's
on the telephone line may result in the devices not ringing
in response to an emergency call. In most, but not all areas,
the sum of the REN's should not exceed five (5.0). To be
certain of the number of devices that may be connected to
the line, as determined by the total REN's, contact the
telephone company to determine the maximum REN for
your calling area.
4. If the equipment causes harm to the telephone network, the
telephone company will notify you in advance. But if
advance notice isn't practical, the telephone company will
notify the customer as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you
believe it is necessary.
5. The telephone company may make changes in its facilities,
equipment, operations, or procedures that could affect the
operation of the equipment. If this happens, the telephone
company will provide advance notice in order for you to
make the necessary modifications to maintain uninterrupted
service.
6. If trouble is experienced with this equipment, please contact
the following for repair and/or warranty information:
Konica Business Technologies, Inc.
Digital Systems Solutions Group & New Product
Development
500 Day Hill Road
Windsor, CT 06095
or
Phone the Konica National Support Center at
1-800-825-5664
If the trouble is causing harm to the telephone network, the
telephone company may request that you remove the
equipment from the network until the problem is resolved.
7. This equipment contains no user serviceable parts. Please
contact your local dealer or qualified service agent.
HOME