Table of Contents
Advertisement
Chapter 12 Interfaces
Each field is described in the table below.
Table 78 Configuration > Network > Interface > Bridge > Edit
LABEL
Show Advance
Settings / Hide
Advance Settings
General Settings
Enable Interface
Interface Properties
Interface Name
Zone
Description
Member
Configuration
Available
Member
IP Address
Assignment
Get
Automatically
Use Fixed IP
Address
IP Address
Subnet Mask
Gateway
Metric
Related Setting
Configure WAN
TRUNK
Configure Policy
Route
272
DESCRIPTION
Click this button to display a greater or lesser number of configuration fields.
Select this to enable this interface. Clear this to disable this interface.
This field is read-only if you are editing the interface. Enter the name of the bridge
interface. The format is brx, where x is 0 - 11. For example, br0, br3, and so on.
Select the zone to which the interface is to belong. You use zones to apply security
settings such as firewall and remote management.
Enter a description of this interface. It is not used elsewhere. You can use alphanumeric
and
()+/:=?!*#@$_%-
This field displays Ethernet interfaces and VLAN interfaces that can become part of the
bridge interface. An interface is not available in the following situations:
•
There is a virtual interface on top of it
•
It is already used in a different bridge interface
Select one, and click the >> arrow to add it to the bridge interface. Each bridge
interface can only have one VLAN interface.
This field displays the interfaces that are part of the bridge interface. Select one, and
click the << arrow to remove it from the bridge interface.
Select this if this interface is a DHCP client. In this case, the DHCP server configures the
IP address, subnet mask, and gateway automatically.
Select this if you want to specify the IP address, subnet mask, and gateway manually.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address for this interface.
This field is enabled if you select Use Fixed IP Address.
Enter the subnet mask of this interface in dot decimal notation. The subnet mask
indicates what part of the IP address is the same for all computers in the network.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address of the gateway. The ISG50 sends packets to the gateway when it
does not know how to route the packet to its destination. The gateway should be on the
same network as the interface.
Enter the priority of the gateway (if any) on this interface. The ISG50 decides which
gateway to use based on this priority. The lower the number, the higher the priority. If
two or more gateways have the same priority, the ISG50 uses the one that was
configured first.
Click WAN TRUNK to go to a screen where you can configure the interface as part of a
WAN trunk for load balancing.
Click Policy Route to go to the screen where you can manually configure a policy route
to associate traffic with this bridge interface.
characters, and it can be up to 60 characters long.
ISG50 User's Guide
Advertisement
Table of Contents
Troubleshooting
