ZyXEL Communications ISG50-ISDN User Manual page 221

The following table describes the labels in this screen.
Table 53 Monitor > Log
LABEL
Show Filter /
Hide Filter
Display
Priority
Source Address
Destination
Address
Source Interface
Destination
Interface
Service
Keyword
Protocol
Search
Email Log Now
Refresh
Clear Log
#
Time
Priority
Category
Message
ISG50 User's Guide
DESCRIPTION
Click this button to show or hide the filter settings.
If the filter settings are hidden, the Display, Email Log Now, Refresh, and Clear Log
fields are available.
If the filter settings are shown, the Display, Priority, Source Address, Destination
Address, Service, Keyword, and Search fields are available.
Select the category of log message(s) you want to view. You can also view All Logs at one
time, or you can view the Debug Log.
This displays when you show the filter. Select the priority of log messages to display. The
log displays the log messages with this priority or higher. Choices are: any, emerg, alert,
crit, error, warn, notice, and info, from highest priority to lowest priority. This field is
read-only if the Category is Debug Log.
This displays when you show the filter. Type the source IP address of the incoming packet
that generated the log message. Do not include the port in this filter.
This displays when you show the filter. Type the IP address of the destination of the
incoming packet when the log message was generated. Do not include the port in this
filter.
This displays when you show the filter. Select the source interface of the packet that
generated the log message.
This displays when you show the filter. Select the destination interface of the packet that
generated the log message.
This displays when you show the filter. Select the service whose log messages you would
like to see. The Web Configurator uses the protocol and destination port number(s) of the
service to select which log messages you see.
This displays when you show the filter. Type a keyword to look for in the Message,
Source, Destination and Note fields. If a match is found in any field, the log message is
displayed. You can use up to 63 alphanumeric characters and the underscore, as well as
punctuation marks ()' ,:;?! +-*/= #$% @ ; the period, double quotes, and brackets are
not allowed.
This displays when you show the filter. Select a service protocol whose log messages you
would like to see.
This displays when you show the filter. Click this button to update the log using the current
filter settings.
Click this button to send log message(s) to the Active e-mail address(es) specified in the
Send Log To field on the Log Settings page (see
Click this button to update the information in the screen.
Click this button to clear the whole log, regardless of what is currently displayed on the
screen.
This field is a sequential value, and it is not associated with a specific log message.
This field displays the time the log message was recorded.
This field displays the priority of the log message. It has the same range of values as the
Priority field above.
This field displays the log that generated the log message. It is the same value used in the
Display and (other) Category fields.
This field displays the reason the log message was generated. The text "[count=x]", where
x is a number, appears at the end of the Message field if log consolidation is turned on
(see Log Consolidation in
to generate into this one.
Section 53.3.2 on page
Table 285 on page 711) and multiple entries were aggregated
Chapter 10 Monitor
710).
221