Konica Minolta bizhub 362 User Manual page 181

9
11
Specify the functions to
be programmed. After all
of the desired functions
have been specified,
touch [Enter].
– If desired, touch
[Quality], [Menu 1] or
[Menu 2], and then
specify the desired
settings. For details
on the settings avail-
able on the Quality
screen, refer to "Specifying the transmission settings" on
page 2-10. For details on the settings available on the Menu 1 and
Menu 2 screen, refer to "Useful transmission functions" on
page 6-3.
12
Check the information to
be registered, and then
touch [Enter].
To change a setting,
touch the button for the
setting to be changed,
and then specify the new
setting.
13
Touch [Enter] in each screen until the standby screen (initial screen) ap-
pears.
Note
If software switch settings were specified to limit use of the FAX Regis-
tration screen to the administrator, [FAX] does not appear in the User Set-
ting screen. In this case, destination can only be registered, edited and
deleted in Administrator mode. For details on the software switch set-
tings, refer to "Specifying software switch settings (machine functions)"
on page 10-69.
9-22
Registering/specifying settings
362/350/282/250/222