To Specify F-Code Settings - Konica Minolta bizhub 362 User Manual

11
In "All Other Documents", the following settings can be specified.
Item
RX Doc.
Settings
Forwarding
Destination
Note
If software switch settings were specified to block faxes received from
senders other than those specified, the machine cannot be set to receive
documents from lines other than the port. For details on the software
switch settings, refer to "Specifying software switch settings (machine
functions)" on page 10-69.

To specify F-code settings

1
In the Administrator mode, click the [Fax/Scan] tab.
– For the procedure to log on to Administrator mode, refer to "Log-
ging on to Administrator mode" on page 11-9.
2
Click [RX Document], then [F-Code].
3
Click an F-code cell.
11-40
Specifying settings using PageScope Web Connection
Description
When "Specifies" is specified in Distribution Conditions, select the processing
method for the received document.
Memory RX: Receives the memory by force.
Forward: Forwards the data to the specified destination.
Print: Prints the document.
Print&Forward: Prints the document and at the same time forwards the data
to the specified destination.
Specify when "Forward" is selected in RX Doc. Settings. Click [Select
Forwarding Destination], select the forwarding destination address, and then
click [Apply].
362/350/282/250/222