Konica Minolta bizhub 362 User Manual page 116

Useful transmission functions
– If "TSI Position" is set to "OFF"
!
Detail
Transmission source information must be programmed in advance. For
details, refer to "Programming a name (TSI Registration)" on page 10-27.
Whether or not transmission source information is printed can be speci-
fied with the TX Settings parameters in Administrator mode. For details,
refer to "Specifying transmission settings (TX Settings)" on page 10-33.
The settings specified for "TSI Selection" are reset after each transmis-
sion.
The transmission information is printed as shown below, according to the se-
lected setting.
If only the "TSI" function was selected
The document can be sent with the name of the sender, the transmission
date and the document number added.
If the "Att./TSI" functions were selected
The document can be sent with the name of the sender added in addition to
the name of the recipient.
362/350/282/250/222
6
6-9