Specifying Software Switch Settings (Machine Functions); Software Sw Settings - Konica Minolta bizhub 362 User Manual

Utility mode
10.22 Specifying software switch settings (machine func-
tions)
By specifying the software switch settings ("Mode Selection", "Bit Selection"
and "Hex Selection"), various machine functions can be changed to meet
your specific needs.
Reminder
Do not change any modes or bits other than those described in this man-
ual.
Note
When "Enhance Security" is set to "ON", the software switch settings
cannot be changed.

Software SW settings

Parameter
Mode Selection
Bit Selection
HEX Selection
Examples of settings for "Bit Selection" (binary numbers) and "HEX Selec-
tion" (hexadecimal numbers) are shown below.
Decimal
number
0
1
2
3
4
5
6
362/350/282/250/222
Description
The parameter to be specified is expressed as a three-digit
number. Use the keypad to type in the value.
The bits are the eight numbers that construct the mode sta-
tus. By specifying a binary number (0 or 1) for each of the bits
(0 through 7), a setting for each parameter can be specified.
Specify a setting for each mode as a hexadecimal number (0
through 9 and A through F). Bit setting "0011 0000" is ex-
pressed as the hexadecimal setting "30".
Specify a mode setting by using either bits or hexadecimal
values.
"Bit Selection" setting (binary
number)
0000 0000
0000 0001
0000 0010
0000 0011
0000 0100
0000 0101
0000 0110
"HEX Selection" setting (hexadeci-
mal number)
00
01
02
03
04
05
06
10
10-69