Table of Contents
Advertisement
Table 47 Class Setup: Add/Edit (continued)
LABEL
To Queue Index
Apply
Cancel
9.6 The QoS Policer Setup Screen
Use this screen to configure QoS policers that allow you to limit the transmission rate of incoming
traffic. Click Network Setting > QoS > Policer Setup. The screen appears as shown.
Figure 70 Network Setting > QoS > Policer Setup
The following table describes the labels in this screen.
Table 48 Network Setting > QoS > Policer Setup
LABEL
Add new Policer Click this to create a new entry.
#
Status
Name
Regulated
Classes
Meter Type
Rule
Action
Modify/Delete
VMG1312-B10C User's Guide
DESCRIPTION
Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
This is the index number of the entry.
This field displays whether the policer is active or not. A yellow bulb signifies that this
policer is active. A gray bulb signifies that this policer is not active.
This field displays the descriptive name of this policer.
This field displays the name of a QoS classifier
This field displays the type of QoS metering algorithm used in this policer.
These are the rates and burst sizes against which the policer checks the traffic of the
member QoS classes.
This shows the how the policer has the Device treat different types of traffic belonging to
the policer's member QoS classes.
Click the Edit icon to edit the policer.
Click the Delete icon to delete an existing policer. Note that subsequent rules move up by
one when you take this action.
Chapter 9 Quality of Service (QoS)
141
Advertisement
Table of Contents
