The Qos Policer Setup Screen - ZyXEL Communications SBG3500-N000 User Manual

Table 47 Class Setup: Add/Edit (continued)
LABEL
Forward to
Interface
To Queue Index
Apply
Cancel

10.6 The QoS Policer Setup Screen

Use this screen to configure QoS policers that allow you to limit the transmission rate of incoming
traffic. Click Network Setting > QoS > Policer Setup. The screen appears as shown.
Figure 80 Network Setting > QoS > Policer Setup
The following table describes the labels in this screen.
Table 48 Network Setting > QoS > Policer Setup
LABEL
Add new Policer Click this to create a new entry.
#
Status
Name
Regulated
Classes
Meter Type
Rule
Action
Modify
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Select a WAN interface through which traffic of this class will be forwarded out. If you select
Unchange, the SBG3500-N Series forward traffic of this class according to the default
routing table.
Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
This is the index number of the entry.
This field displays whether the policer is active or not. A yellow bulb signifies that this
policer is active. A gray bulb signifies that this policer is not active.
This field displays the descriptive name of this policer.
This field displays the name of a QoS classifier.
This field displays the type of QoS metering algorithm used in this policer.
These are the rates and burst sizes against which the policer checks the traffic of the
member QoS classes.
This shows the how the policer has the SBG3500-N Series treat different types of traffic
belonging to the policer's member QoS classes.
Click the Edit icon to edit the policer.
Click the Delete icon to delete an existing policer. Note that subsequent rules move up by
one when you take this action.
SBG3500-N Series User's Guide
195